C) Programming Master/User Codes - Renkforce 754389 Bedienungsanleitung

c) Programming Master/User Codes

Programming depends on which operating mode („Single-User" or „Multi-User"
has been selected, see chapter 10. b).
For the operating mode „Single-User", there is only one user code and one
code for the access lock; the code length has to be 4 digits.
For the operating mode „Multi-User", up to 100 user codes can be set up, as
well as 10 different codes for the access lock. The code length may be 4 to 8
digits.
1. Operating mode „Single-User"
0
+ 4-digit code +
0 234
Example: +

+ 4-digit code +
76

Example: +
2
+ 4-digit code +
2 3333
Example: +
If the code for the access lock is entered later in regular operation, it can only
be revoked by repeated input of the code.
The user code can no longer activate the code lock during access lock.
This function is used, e.g., when access, e.g. to an office, is to be prevented at
night or during specific days.
#
= Programme master code
#
+ = Change master code to 1234
#
= Programme user code
#
+ = Set user code to 9876
#
= Programme code for access lock
#
+ = Set code for access lock to 3333
41