Renkforce 754389 Bedienungsanleitung Seite 50

Example 3: Operating mode „Multi-User" with automatic code
recognition
If you are using the operating mode „Multi-User", the usual pre-setting ex works is
#
that the button „
been entered.
You may avoid this by using a consistent code length for all codes, i.e. you use, e.g., only
5-digit codes for master code, user code and access lock.
Then activate the „Auto-Entry" function (automatic code detection).
If the „Auto-Entry" function is activated, the code lock reviews every input at once. If the
code lock has recognised the right code, it triggers the corresponding function at once
(activate the relay at the user code or deactivate access if entering the code for access
lock). Confirmation of a code with the button „
0000 *
0 #
0 323 #
 0 32 #
 02 223 #
 03 3322 #
 04 5555 #
2  6543 #
2 2 63257 #
50
" has to be pushed after a code (user code or access lock) has
#
" is no longer required.
Call programming mode with the master code
(basic setting ex works „0000"), the yellow LED
is lit permanently
Attention - if another master code is already
programmed, it must be used, of course!
Use operating mode „Multi-User"
Attention - if the operating mode „Single-User"
was activated first, this will delete all codes and
pre-settings (except for the master code)!
Programme master code to „32893"
Programme user code „01" to „83219"
Programme user code „02" to „11223"
Programme user code „03" to „33221"
Programme user code „04" to „85555"
Programme code for access lock for user number
„1" to „68543"
Programme code for access lock for user number
„2" to „63257"