Renkforce 754389 Bedienungsanleitung Seite 40

Operating mode „Single-User":
In this mode, only a single 4-digit user code can be programmed (0000 to 9999). Ever-
yone who knows this user code can, e.g., activate a door opener that is connected to
the code lock.
Furthermore, a code can be programmed for the access lock (also 4-digit). This permits
locking access in the short term for 1....999 seconds or activating/deactivating the
access.
The „Auto-Entry" function (see chapter 10. g) is automatically activated in this operating
mode. Therefore, the relay is activated right after input of the correct 4-digit user code.
It is not required that you push the button „
If desired, however, you may change this by deactivating the „Auto-Entry"
function (see chapter 10. g). Then the input of the 4-digit user code has to be
confirmed with the button „
Operating mode „Multi-User":
In this operating mode, it is possible to programme up to 100 different user codes that
can have 4-8 digits (e.g. 1234, 123456, 98765432 etc.).
Furthermore, up to 10 codes can be programmed for the access lock (4-8 digits). This
permits locking access in the short term for 1....999 seconds or activating/deactivating
the access.
Since the individual codes can be deleted and then reprogrammed, this operating mode
is perfect for use, e.g. in an office where many different persons are to have access.
After input of a 4- to 8-digit code, it must be confirmed with the button „
„Auto-Entry" is deactivated, home position).
If the user code is correct, the relay is then activated.
Important!
The code lengths of master and user code can be different (e.g. 8-digit master
code and 5-digit user code).
If, however, the function „Auto-Entry" (see chapter 10. g) has been activated,
the code length of master code and user codes must be the same (each 4-8
digits). After code input, confirmation with the button „
this case.
40
#
" after the user code.
#
".
#
" (if the function
#
" is not required in