Werbung
Verfügbare Sprachen
Verfügbare Sprachen
O P E R A T I N G I N S T R U C T I O N S
2.4 GHz Digital Camera
Item no. 75 41 09
Intended use
The product is intended to be used for the expansion of the 2.4 GHz digital wireless DVR set (order no.
752688)
The camera is suitable for use outdoors (IP66); however, the enclosed wall plug transformer may
be used only in dry, enclosed indoor areas; it must never get damp or wet!
Please bear in mind that it is prohibited by law to observe strangers with a camera without their knowledge
and consent. Observe the rules and regulations of the country where you are using the camera.
The safety instructions must be observed at all times!
Any other use than that described above may damage the product. Moreover, this may give rise to hazards
such as short-circuiting, fi re, electric shock, etc. No part of the product may be modifi ed or converted!
This product complies with the applicable National and European requirements. All names of companies and
products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Digital camera with bracket
• Wall plug transformer
• Operating Instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We do not assume any liability for any consequential damage!
Nor do we assume any liability for material and personal damage caused by improper use
or non-compliance with the safety instructions! In such cases, the warranty will be null
and void.
General safety instructions
• The unauthorised conversion and/or modifi cation of the unit is not permitted because of safety
and approval reasons (CE).
• This product is not a toy, and should be kept out of the reach of children. Children cannot
assess the dangers arising from incorrect use of electrical devices. Be especially careful if
children are around.
• Do not leave packaging material carelessly lying around since it could become a dangerous
plaything for children.
• If you sell this product or give it away, you must hand over these operating instructions.
• Handle the product with care, it can be damaged by impacts, blows, or accidental drops, even
from a low height.
• In commercial institutions, the accident prevention regulations of the Employer's Liability In-
surance Association for Electrical Systems and Operating Materials are to be observed.
• If you have any questions that are not answered in this manual, please contact our technical
service or another specialist.
Product Specifi c Safety Instructions
• The camera is suitable for use in indoor and outdoor areas (IP66).
• The wall plug transformer is solely intended for use in dry, enclosed interiors; it must not get
damp or wet. Never touch it when your hands are wet or damp! Otherwise, there is a risk of a
life-threatening electric shock!
• The product should not be exposed to extreme temperatures, direct sunlight, moisture, in-
tense vibrations or heavy mechanical stresses. This can cause malfunctions and/or faults.
• Never use the product immediately after it has been brought from a cold room into a warm
one. Condensation that forms might destroy the device. Furthermore, there is a danger of an
electric shock. Wait until the product reaches room temperature and the condensation has
evaporated. This may take several hours. Then connect the wall plug transformer with the
mains supply and put the product into operation.
• If the product or a part thereof is faulty, it must not be used. It may be repaired only by a
specialist.
• A safe operation can no longer be assumed, if:
- the product shows visible signs of damage,
- the product does not work any longer
- the product was stored for a longer period of time in unfavourable conditions
- it was exposed to heavy loads during transport
• If you have reason to assume that safe operation is no longer possible, disconnect the product
immediately and secure it against inadvertent operation. Disconnect the wall plug transformer
from the mains voltage!
• Never pull on the power supply's cable, only unplug the power supply from the wall socket by
pulling on the casing.
www.conrad.com
Version 09/11
Controls
2
3
1
2
3
4
5
6
Assembling the Camera, Start-up
The sunscreen is attached to the camera housing with a screw.
On the other side of the camera, there is another thread available for
the mounting bracket.
Screw the radio antenna securely into the corresponding socket on
the back, but do not use any force when so doing.
Do not point the camera directly at a source of bright sunlight or at
strong or indirect illumination as this may lead to overexposure and
a fuzzy picture.
Do not mount the camera in the direct vicinity of metal objects or
other transmitters on the same frequency (e.g. WLAN devices or
similar), since this reduces the range.
The camera is suitable for outdoor use (IP66).
Choose a suitable position to install the camera, where it is directed
towards the object to be monitored.
Mark the installation position on the wall (e.g. with a pencil) and se-
cure the bracket to the wall. Use appropriate screws and, if neces-
sary, plugs.
Make sure that cables or wires are not damaged when drilling or
bolting in place.
Screw the camera onto the bracket and position the camera.
Connect the camera to the wall plug transformer and plug the wall
plug transformer into a standard wall socket.
• If the product is not to be used for some time (e.g. during storage), unplug the wall plug trans-
former.
• Always unplug the wall plug transformer from the wall socket before cleaning the device.
• In the event of a thunderstorm, unplug the power supply unit for safety reasons.
• The design of the power transformer complies with protection class II. Only connect the wall
plug transformer to a standard wall socket connected to the public supply.
• When mounting the product, make sure that the connection cable is not squeezed or dam-
aged by sharp edges.
• In the event of unusually high temperatures, strange noises or smoke during use, unplug the
product from the mains immediately.
• Do not use this product in hospitals or medical institutions. Although the product emits only
relatively weak radio signals, these may lead to the malfunction of life-support systems.
• Never use the product in the vicinity of medical devices (e.g. pacemakers).
• Make sure that the product is suffi ciently ventilated. Do not operate the product when it is
covered.
• The use of the surveillance camera system does not replace personal supervision of children
or people who require special assistance, but only serves as a support to this supervision.
1
4
5
6
7
8
Radio antenna
7
Infrared LEDs
Photo sensor
8
Mounting Bracket
"POWER" status LED
9
"PAIR" button
Camera lens
10 Connection for the power supply
"LINK" status LED
11 Microphone
Movement sensor
12 Wall plug transformer
The wall plug transformer is solely intended for use in dry,
enclosed interiors; it must not get damp or wet. Otherwise,
there is a risk of a life-threatening electric shock!
12
9
10
11
Werbung
