Spray Arms; Hose Filter - Nabo GSI 1500 Gebrauchsanweisung

Hose filter

Water is prevented by the inlet hose filter so as to avoid any damage to your machine because of any
contamination (sand, clay, rust etc.) that might be occasionally carried in through the mains water
supply or the indoor plumbing, and to forestall such complaints as yellowing and formation of deposits
after washing. Check the filter and the hose from time to time and clean them if necessary. To clean
the filter, first turn off your tap and then remove the hose. After removing the filter from the hose, clean
it under the tap. Insert the cleaned filter back into its place inside the hose. Refit the hose.

Spray arms

Check whether or not the holes for the upper
and lower spray arms are clogged. If there is
any clogging, remove the spray arms and clean
them under water.
You can remove the lower spray arm by pulling
it upwards, while the upper spray arm nut can be
removed by turning the nut to the left.
Be sure that the nut is perfectly tightened when
refitting the upper spray arm.
31