Filling With Rinse Aid And Making The Setting - Nabo GSI 1500 Gebrauchsanweisung

Observe the instructions on packagings when using such products.
•
If such detergents are in the form of tablets, never put them into the interior section or the
•
cutlery basket of the dishwasher. Always put the tablets into the detergent compartment in
the detergent dispenser.
They produce good results for certain types of usage only. If you are using this type of
•
detergents, you need to contact the manufacturers and find out about the suitable
conditions of use.
When the conditions of use of such products and the machine settings are appropriate,
•
they ensure savings in salt and/or rinse aid consumption.
Contact the detergent manufacturers if you are not obtaining good wash results (if your
•
dishes stay calcareous and wet) after having used 2 in 1 or 3 in 1 detergents. The scope of
warranty for your machine does not cover any complaints caused by the use of these types
of detergents.
Recommended usage: If you are using a combined detergent, then add rinse agent into your
machine ,switch the rinse agent settings into its lowest (1) position and active the tablet
detergent button in order to obtain better results.If the water hardness level is above level 4,then
it is necessary to fill in the salt container with salt. t is not recommended to use combined
detergents in fast programs.
Solubility of the tablet detergents produced by different companies can vary
depending on the temperature and time. Therefore, it is not recommended to use
such detergents in short programs. It is more suitable to use powder detergents in such
programs.
Warning: Should any problem, which you have not encountered before, arise with the use of
this type of detergents, contact the detergent manufacturers directly.
When you give up using combined detergents
Fill the salt and rinse aid compartments.
•
Adjust the water hardness setting to the highest position and run an empty-wash.
•
Adjust the water hardness level.
•
Make the suitable rinse aid setting.
•

Filling with rinse aid and making the setting

Rinse aid is used to prevent the stay of white water drops, lime
stains, white film strip-shaped stains that may form on the dishes,
as well as to increase the drying performance. Contrary to the
popular beliefs, it is used not only for obtaining shinier dishes but
also for obtaining sufficiently dried dishes. For this reason, care
should be taken that there is adequate amount of rinse aid in the
rinse aid compartment and only polishing material produced for
use at dishwashers should be
used.
If the rinse aid lamp on the
control panel becomes on fill
the rinse aid compartment with
rinse.
To put rinse aid, remove the
rinse aid compartment cap by
turning it.1 Fill the rinse aid
compartment with rinse aid
until the rinse aid level indicator becomes
close it by turning it in a way that the nails will correspond to one
another. By checking the rinse aid level indicator on the detergent
19
dark;2 refit the cap and