Prior To Using The Machine; Preparing The Machine For Use; The Importance Of Water Decalcification; Filling With Salt - Nabo GSI 1500 Gebrauchsanweisung

IF AVAILABLE
Prior to using the machine for the first time
Check whether the electricity and supply water specifications match the values indicated by the
•
installation instructions for the machine.
Remove all packaging materials inside the machine.
•
Set the water softener.
•
Add 1 kg salt into the salt compartment and fill with water up to a level at which it will almost
•
overflow.
Fill the rinse aid compartment.
•

PREPARING THE MACHINE FOR USE

The importance of water decalcification

For a good washing function, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white
lime residues will remain on the dishes and the interior equipment. This will negatively affect your
machine's washing, drying and shining performance. When water flows through the softener system,
the ions forming the hardness are removed from the water and the water reaches the softness
required to obtain the best washing result. Depending on the level of hardness of the inflowing water,
these ions that harden the water accumulate rapidly inside the softener system. Therefore, the
softener system has to be refreshed so that it operates with the same performance also during the
next wash. For this purpose, dishwasher salt is used.

Filling with salt

Use softener salt specifically produced for use in dishwashers. To put softener salt, first remove the
your dishwasher, the salt compartment gets filled with water. Therefore, put the softener salt prior to
starting your machine.
This way, overflowing salt gets immediately cleaned up through the wash operation. If you are not
going to wash any dishes immediately after putting salt, then run a short washing program with an
empty machine in order to avoid any damage ( to prevent corrosion )to your machine due to the salt
overflow while filling in the salt container.
lower basket and then open the salt
compartment cap
counter clockwise.1 2
compartment with 1kg salt and
water3 at overflowing level If
available,using the funnel4
will make filling easier; refit the cap
and close it.
If the salt warning lamp on the control
panel becomes on fill the salt
compartment with salt again.
Fill the salt compartment with
water at first use only.
If you put a tablet into the salt
compartment, do
compartment completely.
recommend that you use small-
grained or powder softener salt.
Do not put table salt into your
machine. Otherwise, the function of
the softener compartment may
decrease over time. When you start
15
by turning it
At first fill the
provided
not fill the
We