Zoom Mode (Qvga); Quad Display Or Automatic Switching Between Channels - Conrad 75 20 01 Bedienungsanleitung

12. Zoom mode (QVGA)

Press the "Zoom" button
mode is active, "ZOOM" is displayed to indicate it (see chapter „9. Display indica-
tors").
If you are not in zoom mode, you are in normal display mode (VGA).
In zoom mode, you can move the camera image up, down, left, or right. To do that,
hold down the "Up"
function button (14).
Press the "Zoom"
displayed.
13. Quad display or automatic switching between
channels
You can manually select the individual camera channels by shortly pressing the
camera channel selection button
You can also set a time (5, 10, 15, or 20 seconds) to automatically switch to the next
camera channel. Proceed as follows to use this function:
• Press "OK" on the multi-function button (14) of your receiver. The settings menu
opens up.
• Press the "Up"
select menu item "Scan Time".
• Press the "Left"
select the desired time (5, 10, 15, or 20 seconds).
(16) to enter or exit zoom mode (QVGA). When zoom
, "Left" , "Down"
button (16) again to exit zoom mode. "ZOOM" is no longer
(15).
or "Down" section of the multi-function button (14) to
or "Right" section of the multi-function button (14) to
, or "Right" sections of the multi-
41