Herunterladen Inhalt Inhalt Diese Seite drucken

Fujitsu EF-42 Bedienungsanleitung Seite 15

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 38
Batteries
Note: Check the type of batteries used in your fl ash and read the ap-
propriate sections.
The following describes the proper use of batteries and how to prolong
their life. Incorrect use can shorten battery life or cause leakage, over-
heating, fi re, or explosion.
■ Cautions: Handling the Batteries
• Do not expose to fl ame, or heat.
• Do not transport or store with metal objects such as necklaces or
hairpins.
• Do not use batteries that are leaking, deformed, discolored, or with
other abnormal states.
• Do not mix old and new batteries, batteries with diff erent charge lev-
els, or batteries of diff erent types.
• If the fl ash will not be used for an extended period, remove the bat-
teries. Note that various settings of the fl ash will be reset.
• The batteries may be warm to the touch immediately after use. Turn
the fl ash off and allow the batteries to cool before handling.
• Battery capacity tends to decrease at low temperatures below 10 °C
(50 °F). Keep spare batteries in a pocket or other warm place and ex-
change as necessary. Cold batteries may recover some of their charge
when warmed.
• Fingerprints and other stains on the battery terminals can aff ect a
number of fl ash fi ring. Thoroughly clean the terminals with a soft, dry
cloth before inserting batteries in the fl ash.
■ Rechargeable AA Ni-MH Batteries
The capacity of Ni-MH batteries may be temporarily reduced when
new, after long periods of disuse, or if they are repeatedly recharged
before being fully discharged. This is normal and does not indicate
a malfunction.
The fl ash draws a small amount of current even when off . Ni-MH bat-
teries that have been left in the fl ash for an extended period may be
drawn down to the point that they no longer hold a charge. Batteries
that no longer hold a charge even after repeatedly being discharged
and recharged have reached the end of their service life and must be
replaced.
Ni-MH batteries can be recharged in a battery charger (sold separately).
Batteries may become warm to the touch after charging. Refer to the
instructions provided with the charger for more information. Use the
charger with compatible batteries only.
Ni-MH batteries gradually lose their charge when not in use.
■ Disposal
Dispose of used batteries in accord with local regulations.
Environmental disposal of batteries is advisable.
The apparatus is premised on use in warm climates.
Liquid Crystal
In the event that the LCD panel is damaged, care should be taken to
avoid contact with liquid crystal. Take the urgent action indicated
should any of the following situations arise:
• If liquid crystal comes in contact with your skin, clean the area with a
cloth and then wash thoroughly with soap and running water.
• If liquid crystal enters your eyes, fl ush the aff ected eye with clean wa-
ter for at least 15 minutes and then seek medical assistance.
• If liquid crystal is swallowed, rinse your mouth thoroughly with water.
Drink large quantities of water and induce vomiting, then seek medi-
cal assistance.
Although the display is manufactured using extremely high-precision
technology, it may contain pixels that are always lit or that do not light.
This is not a malfunction, and images recorded with the product are
unaff ected.
ENGLISH
Caring for the Flash
To ensure continued enjoyment of the product, observe the following
precautions.
■ Storage and Use
If the fl ash will not be used for an extended period, remove batteries.
Do not store or use the fl ash in locations that are:
• exposed to rain, steam, or smoke
• very humid or extremely dusty
• exposed to direct sunlight or very high temperatures, such as in a
closed vehicle on a sunny day
• extremely cold
• subject to strong vibration
• exposed to strong magnetic fi elds, such as near a broadcasting an-
tenna, power line, radar emitter, motor, transformer, or magnet
• in contact with volatile chemicals such as pesticides
• next to rubber or vinyl products
■ Water and Sand
Exposure to water and sand can also damage the fl ash and its internal
circuitry and mechanisms. When using the fl ash at the beach or sea-
side, avoid exposing the fl ash to water or sand. Do not place the fl ash
on a wet surface.
■ Condensation
Sudden increases in temperature, such as occur when entering a heat-
ed building on a cold day, can cause condensation inside the fl ash. If
this occurs, turn the fl ash off and wait for droplets to evaporate.
EN-2

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis