Water Hose - Health Aqua Technology Aqua-Q Bedienungsanleitung

Water hose:

Important!
Please ensure that the hose length is suitable for the filter system. Make sure that there
are no kinks or bends in the hose in order to avoid permanent damage.
1. You can now use a Stanley knife or cable cutter to shorten the water hose to the required length.
Caution: always cut away from your body!
2. You can now push the water hose onto the filter system's water supply fitting.
3. To release the water hose, use your fingernail to remove the blue clip.
4. Push the outer mounting ring together whilst pulling out the hose at the same time.
5. To fix the water hose into place, push the end of the water hose into the opening of the
„quick-coupling connection".
6. You can now insert the blue clip into the slot. Once you have inserted the clip, the hose is fixed
into place and securely connected.
7. You have now finished connecting the cold water supply to the "Aqua-Q" and the filter system
to the water supply.
Important!
Please do not yet open the water inlet!
Wastewater bracket:
1. Remove the wastewater bracket from its packaging and unscrew the two side screws.
Important!
Please ensure that the black seal is adhered to the inside of the wastewater bracket.
2. Drill a 7mm-large hole in the drain pipe, approx. 7-8cm above the drain trap.
3. Unscrew the screw in the wastewater bracket and insert the wastewater hose into the opening.
4. Push the wastewater hose into the hole drilled in the drain pipe. You can now screw on the
second half of the wastewater bracket.
5. Once you have done this, you can cut the wastewater hose down to the required length.
25