Cold Water Connection - Health Aqua Technology Aqua-Q Bedienungsanleitung

Cold water connection:

Important!
You now need to carry out work on the cold water connection under the sink. You should
therefore first shut off the cold water valve under the sink.
You can check whether you have shut off the correct valve by turning on the regular tap
in the sink. No water should come out! The water connection piece consists of two individual
parts that need to be joined together.
First seal off the external thread of the cold water connection with the Teflon tape. To do so,
wrap the Teflon tape around the thread 4 to 5 times in the opposite direction to the thread.
Important!
1. Please ensure that the opening (for the water supply) is not covered by any Teflon tape.
2. Check that the rubber seal is inserted.
3. Use the open-ended spanner to twist the flexible water hose off the corner valve.
In some cases, you will need to use a pipe wrench to hold the corner valve in order to prevent
it from turning with the hose. You can now attach the cold water connection to the corner valve.
4. Once you have done this, you can connect the flexible water hose to the cold water connection.
24