Technical Data - Conrad C-839 Bedienungsanleitung

Press the "Set" button again and setting the alarm time
is complete. The time of day is indicated in the display
again.
Press the "Set" button again and hold briefly; the dis-
play flashes. Press the "Mode" button as often as re-
quired. The following symbols appear in the display:
" " (alarm symbol) for the wake-up time at
which the beep tone will sound. To cancel
the beep tone, please press the "Mode" but-
ton.
" " (bell symbol) for the hours signal; at every
full hour a brief beep tone occurs.
" " " " both functions are implemented.
When one or both symbols do not appear in the display,
the function(s) is/are inactive.
Press the "Set" button 3 times and the time of day will
again be indicated in the display.
22
Time of day, alarm time
and date function
The settings have been carried out as described above.
The set time of day is indicated in the display. The fol-
lowing functions can now be carried out:
Press button Display indication
"Mode" button 1x Alarm time (hours & minutes). Af-
ter a few seconds the time of day
again
"Mode" button 2x Date (month & date). After a few
seconds the time of day again
"Mode" button 3x Seconds
"Mode" button again Time of day

Technical Data

Power supply: . . . .Type AAA 1.5 V (qty 2); 1.5 V Renata
384 or 392 button cell (qty 1)
Output power: . . . .approx. 200 mW
Frequency range: .FM: 88 - 108 MHz,
AM: 530 - 1600 kHz
Antenna: . . . . . . . .FM: via throw-out antenna,
AM: built-in ferrite antenna
23 23