Tomek TX RX01 Gebrauchsanleitung Seite 9

2.2 - NEW DEVICE
When turned on, the receiver has only the
N.B.: there may be a weak lighted signal on the
2.3 - TEMPORARILY FORCING THE STATE OF THE CONTROL OUTPUT (for example, to test the system)
A) TRANSMITTER NOT YET COUPLED OR NOT ACTIVE
!
key
Hold down the " " until there is a brief audible signal, then release it: the control is activated and the corresponding
steady on (fig.3).
The control will remain activated for 5 minutes, at the end of which, an audible signal will continue for
its imminent deactivation (fig.4): if you wish to keep it active, press the "
otherwise, when the signal ceases, the control will be deactivated.
Cancelling the temporary forcing of the control
!Briefly press the
" Reset key " ; when released the temporary forced control is
cancelled (fig.5).
N.B.: Before performing this operation, consult chapter 2.9
B) TRANSMITTER COUPLED AND HEAT REGULATION ACTIVE
The above-indicated operations can also be performed, using the same methods, during normal heat regulation operation; in this case,
the temporary forced control will cause the transmitter to be excluded and the reversal of the command status: if active, it will be
deactivated and vice versa. During the forced state, the "
ON LED lit.
lower LED of the VMETER
Fig. 3
" Reset "
" key is not functional.
Tomek GmbH - haustechnik@tomek.at -- 01/61003-0
, due to the presence of radio interference.
5 seconds
" key again while the audible signal is sounding;
5 minutes
5 s
RESET
G
B
LED
is
to alert the operator of
Fig. 4
Fig. 5
9