Tomek TX RX01 Gebrauchsanleitung Seite 12

2.7 - SIGNALING A TRANSMITTER MALFUNCTION
The receiver reports two types of transmitter anomalies:
G !
Failure to receive a radio signal for more than 30 minutes
!
B Transmitter battery almost dead
In both cases, the signal is given by the intermittent,
channel LEDs .
ATTENTION: in the case of the lack of a radio signal, the control of the load is also
deactivated (Burner control deactivated).
2.8 - DELETING A TRANSMITTER COUPLING
It is possible to delete a transmitter coupling even if it is not able to transmit the Test signal.
!
Press and hold the "
coupling is erased from the memory of the receiver and the channel is free.
ATTENTION: in the event the key is released before the
beginning of the long beep, the operation is automatically
cancelled and the command output is set to
Forced" (see paragraph 2.3).
Press " RESET Key " to return to normal operation.
2.9 - RESET
The RESET command on the receiver cancels all the data stored in the device
except for the transmitter coupling.
!
Briefly press the RESET key
with a beep and the ON LED
12
simultaneous lighting of the
(even in a state of malfunction)
" key until the end of the sequence of beeps shown in the figure; then release it. The transmitter
"Temporary
: when it is released, all the LEDs
will be steady lit.
Tomek GmbH - haustechnik@tomek.at -- 01/61003-0
ON and
6 s
When the key is released during this period of
time, the operation is cancelled
Fig. 12
Fig. 13
RESET
will light together
ON
FROM THE RECEIVER
4
s
4 s 1 s 1 s 1 s
ON
2
s
Fig. 11