Installing The Base On The Wall - Tomek TX RX01 Gebrauchsanleitung

1.2 - INSTALLING THE BASE ON THE WALL

Installing the device: INDEPENDENT - FIXED
ATTENTION: INSTALLATION MUST BE PERFORMED AFTER SECTIONING
THE MAINS SUPPLY - 230 V . ~
For installation, it is necessary to separate the front part, complete with
electronic card, from the base.
!
First on one side and then on the other, insert a screwdriver in the slots
located on the sides of the product, exerting light pressure on the locking
catch, then, with a small forward rotation of the screwdriver (as shown in
figure 3.i), lift the front.
!
Remove the front from the base (the resistance to removal is due to the
coupling pin on the terminal strip) fig. 4.i.
From the base, remove the parts prepared for the passage of the connection wires shown in fig. 5.i.
!
Pass the connection wires through the opening you have made.
!
Attach the base to the wall (or built-in box), with 2 screws using the pairs of holes
!
Make the electrical connections to the terminals located on the base as shown in the next chapter.
D = Catches for locking the
front to the base
Removable area for the
passage of wires
(Installation with built-in box)
C B A A B C
D D
Tomek GmbH - haustechnik@tomek.at -- 01/61003-0
RESET
RESET
( A-A, B-B, C-C ) provided (fig. 5.i).
Removable areas for
installation with trunking
system.
ON
G
B
Fig. 3.i
ON
Fig. 4.i
Fig. 5.i
5