Tomek TX RX01 Gebrauchsanleitung Seite 10

2.4 - COUPLING TO A TRANSMITTER
Activate the "Test" state on the transmitter to be coupled, as explained in the chapter
transmitter manual.
G
A) - FIRST COUPLING TO A TRANSMITTER
B
ON THE RECEIVER
The LED " " is off (receiver not coupled)
!
Hold the " " key pressed until you hear a single audible signal; then let go:
flash (fig.6).
The transmitter is coupled to the receiver.
Deactivate "Test" mode
the transmitter manual.
ATTENTION: if the "
that the transmitter in " Test
the coupling: deactivate "
To cancel the coupling: hold down the "
release it; the LED is off (fig.7).
B) - SUBSEQUENT TRANSMITTER COUPLINGS
ON THE RECEIVER
The " " LED is steady on
!
Hold the " " key pressed until you hear a single beep; then release it:
flashing (fig. 8).
The new transmitter (in "Test" mode)
Deactivate "Test" mode
ATTENTION: the coupling status is stored in permanent memory and is not erased by the
N.B.: test mode on the transmitter automatically terminates 3 minutes from activation.
10
ON THE TRANSMITTER , as explained in the specific chapter of
" LED is flashing at the beginning of the operation it means
" mode has already been coupled to the receiver. To confirm
Test
" mode on the transmitter.
" key until you hear a single beep; then
Deactivate " Test " mode on the TRANSMITTER.
(receiver already coupled to another transmitter)
is coupled to the receiver.
ON THE TRANSMITTER, as explained in the specific chapter of the transmitter manual.
Tomek GmbH - haustechnik@tomek.at -- 01/61003-0
the LED will
(such as: replacing the transmitter)
the LED is
Reset
" Coupling to the receiver " in the
2
s
2
s
2
s
command or by a power failure.
Fig. 6
Fig. 7
Fig. 8