Electrical Connections - Tomek TX RX01 Gebrauchsanleitung

1.3 - ELECTRICAL CONNECTIONS

SWITCH MAINS SUPPLY 230 V~
G
With reference to figures 6.i, 7.i and 8.i
B
Make the connection to the mains supply
terminal 1 = NEUTRAL
terminal 2 = LINE
Make the connections to the device to be controlled
(Such as: a burner, pump, or 2 or 3-wire motorized solenoid valve, servomotor)
Terminal 3 = line, available for controlling the load
terminal 4 = contact normally closed
terminal 5 = contact normally open
terminal 6 = common
NOTES AND INSTRUCTIONS FOR THE INSTALLER
!
Also pay careful attention to the instructions for the device being
controlled.
!
In the presence of loads with absorption higher than the data on the
product rating plate, interpose a power relay or a suitably
dimensioned contactor. In the presence of highly inductive loads
we recommend connecting an RC filter in parallel with the load.
!
When making the electrical connections, in the case of a wall
installation without built-in box, pay particular attention that the
cabling is properly placed and does not interfere with the correct
closing of the front on the base.
!
In the case of installing the receiver on a metal wall, use double
insulated cables for the electrical connections.
6
OFF
:
Tomek GmbH - haustechnik@tomek.at -- 01/61003-0
L
230 V~
N
1 2 3 4 5 6
Example of a burner
connection
N L1 L2
Receiver
L
230 V~
N
N
1 2 3 4 5 6
Example of a solenoid
valve connection - 2-wire
N L1 L2
Receiver
L
230 V~
N
N
Close
Open
1 2 3 4 5 6
Example of a motorized
solenoid valve connection
- 3-wire
N L1 L2
Receiver
Burner
Fig. 6.i
Solenoid valve
Fig. 7.i
Solenoid valve
Fig. 8.i