Siemens Gigaser 108 Kurzbedienungsanleitung Seite 22

Quick Start Guide
Operating Mode Repeater
After configuring the basic and security settings for Operating Mode Repeater, you
must activate the WDS function on the access point. The operating instructions for the
device will tell you how to do this.
Configuration is complete once your Gigaset WLAN Repeater 108 has successfully con-
nected to the access point. Remember, however, that the Gigaset WLAN Repeater 108
automatically assigns IP addresses to connected devices. You may have to alter the con-
figuration if you have configured your Gigaset wireless router differently from its factory
default settings. Further information about this will be found in the detailed operating
instructions. You should restart all the devices once all the configuration settings have
been made.
Operating Mode Access point
Once you have configured the basic and security settings for Operating Mode Access
point, connect all the PCs, you wish to include in your wireless network to the Gigaset
WLAN Repeater 108 by setting the correct SSID and the appropriate WEP encryption for
your network adapters on it. Informations about this will be found in the operating
instructions for the network adapter.
When you have configured your wireless network, you can connect the Gigaset WLAN
Repeater 108 to a router or modem via the LAN socket and the wireless network to a
wired network.
Operating Mode Ethernet adapter
Carry out the following steps in the order shown:
ì
Open the configuration programme as described on page 19.
ì
Then run the basic settings wizard.
20