Philips RQ1180 Bedienungsanleitung Seite 11

Problem
The shaver does not work
when I press the on/off button.
The shaver is not entirely clean
after I clean it in the Jet Clean
System.
The Jet Clean System does not
work when I press the on/off
button.
The shaver is not fully charged
after I charge it in the charger/
Jet Clean System.
Possible cause
Long hairs obstruct the shaving heads.
The Jet Clean System has not cleaned the shaver
properly, because the cleaning fluid in the cleaning
chamber is soiled or the cleaning fluid level is too
low.
The rechargeable battery is empty.
The travel lock is activated.
The shaving head holder is soiled or damaged to
such an extent that the motor cannot run.
The temperature of the shaver is too high. In this
case, the shaver does not work.
The cleaning fluid in the cleaning chamber is soiled.
The cleaning fluid level is too low. If the fluid
volume in the cleaning chamber drops below the
minimum level during the cleaning program, the
program aborts.The cleaning light and the 'cleaning
chamber empty' symbol flash at intervals and the
holder returns to its starting position.
You have used another cleaning fluid than the
original Philips cleaning fluid.
The Jet Clean System is not connected to the
mains.
There is no electrical connection between the Jet
Clean System and the shaver.
You have not placed the shaver in the charger/Jet
Clean System properly.
Solution
Clean the shaving heads by following the steps of the
extra-thorough cleaning method (see chapter
'Cleaning and maintenance').
Clean the shaver thoroughly before you continue
shaving. If necessary, clean and refill the cleaning
chamber (see chapter 'Cleaning and maintenance').
Recharge the battery (see chapter 'Charging').
Press the on/off button for 3 seconds to deactivate
the travel lock.
Clean the shaving head holder or replace it (see
chapters 'Cleaning and maintenance' and
'Replacement').
Let the shaver cool down. As soon as the
temperature of the shaver has dropped sufficiently,
you can switch on the shaver again.
Empty and rinse the cleaning chamber.
Refill the cleaning chamber with cleaning fluid to a
level between the two lines (see chapter 'Cleaning
and maintenance').
Only use HQ200 Philips Cleaning Fluid.
Put the small plug in the Jet Clean System and put
the adapter in the wall socket.
Press the shaver tightly into the holder to lock it into
place.
Make sure you press the shaver until it locks into
place.
English
11