Handling - Renkforce 1362731 Bedienungsanleitung

Example:
DIP switches 1, 3 and 5 are set to „ON", all other switches are set to „OFF".
DMX starting address = 1 + 4 + 16 = 21
• The device requires two free DMX channels. The first DMX channel is the DMX starting address. The
second DMX channel follows the starting address.
• The amount of fog is adjusted via the DMX value of the first DMX channel.
Value „0"
Value „255"
• The fan speed is adjusted via the DMX value of the second DMX channel.
Value „0"
Value „255"

11. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation has eva-
porated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains unit from the mains socket after use.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never touch the device in operation or right afterwards, because this area heats up strongly particularly
in the area of the fog exit opening. There is a danger of burns.
• Never use contaminated fog liquids. Close the tank and the storage container for your fog liquid immedi-
ately after filling.
• Always empty the tank before transporting the device or if you are not using it for a longer period.
• Use only water-based fog liquid. Suitable fog liquids are listed in the „Technical Data" section.
30
> No fog emission
> Maximum fog emission
> Minimum fan speed
> Maximum fan speed