Mounting The Base - Schego schegoLUX light Bedienungsanleitung

schegolux.book Seite 15 Dienstag, 29. Juni 2010 6:05 18

Mounting the base

1. Lay the washer on the base (Fig. 2/A) you would like to use. Make sure that the washer
is placed into the recess provided for this purpose.
2. Screw the base anti-clockwise onto the thread of the halogen lamp against the stop.
3. Secure the nut on the top end of the thread to avoid undesired loosening of the base
(Fig. 2/B). For this purpose use the special spanner (Fig. 1/5), hold the base and turn
the nut clockwise with the spanner.
NOTE:
Check the tight fit of the base by holding the base and turning the halogen lamp. The
spotlight must be free to rotate 360° to right and left, without the base coming loose.
Mounting/changing the attachment
You can choose from two different attachments.
Reflector attachment (Fig. 1/8)
Spotlight attachment (Fig. 1/9)
Please proceed as follows to mount or replace the attachment:
1. Make sure that the halogen lamp has cooled down completely.
2. If an attachment is mounted: Carefully pull the attachment off the halogen lamp
(Fig. 3/A).
3. Slide the new attachment over the halogen lamp.
Placing the schegoLUX~light
With mounting foot
1. Drill a hole into the subbase and insert a suitable dowel into the hole.
NOTE:
The brass dowel (Fig. 1/6) included in the scope of delivery is most suitable for
subbases consisting of wood or stone. If you use the brass dowel in a very hard material
(e.g. granite) you must make sure that the dowel is inserted for at least 10 mm.
2. Place the round recess in the mounting foot (Fig. 4/1) above the drilled hole and
fasten the halogen lamp with a screw (not part of the delivery).
NOTE:
In case of too lose subbases assembled the mounting foot on a stone or heavy slab and
then move the halogen lamp to the desired location.
Mounting the base
15