Handling And Operation; Switching Off The Device - Hama BASIC A41 Bedienungsanleitung

g

5. Handling and Operation

5.1 Instructions for use
Always wait for a lamination process to nish before starting the
next.
5.2 Switching on the device
‹ Press the on/off switch
‹ The device automatically heats to the correct temperature for la-
minating lms with a thickness of
green as soon as the device is ready.
5.3 Lamination
Place the document to be laminated in the appropriate pouch (see
gure).
Insert the lm pouch into the front opening of the device (4).
sure that the sealed end is inserted rst.
NOTE
‹ The document is returned at the rear (5).
‹ If an item has not been fully laminated, repeat the rst steps.
CAUTION!
NOTE

5.4 Switching off the device

‹ Press the on/off switch
lamp
8
Film pouches of all sizes should be inserted at the centre of
the front opening so that they pass through the sensor.
Laminated items coming out of the device may be too hot to
touch.
The laminated sheet is hot and can be bent easily. Place the
item on a at surface and leave to cool so that it does not
curl at the edges.
2
goes out.
3
to switch on the device.
m. The ready lamp ( ) turns
3
to switch off the device. The ready
ake
A 41