Product Description - Cocraft HL 10-S Original Bedienungsanleitung

Product description

1. Laser window
2. Levelling warning
3. Battery cover
4. ¼" tripod adaptor
5. Clamp stand
6. ON/OFF power switch
Operating
instructions
Batteries
1. Remove the battery cover (3) and
insert 2 batteries (AAA/LR03). Note
the polarity markings on the bottom of
the battery compartment to ensure
correct insertion.
2. Refit the battery cover.
Switching the laser level on
1. Place the laser level in a suitable location.
2. Set the power switch (6) to the ON position (press it upwards). The laser beams
will appear on the surface the laser level is pointed towards and the levelling
warning (2) light will shine green (if the laser level is not inclined more than 3°).
3. Set the power switch (6) to OFF (press it downwards) to switch the laser level off.
Note:
• Never leave the laser level switched on unattended. Always switch it off after use.
There is always a risk that someone could be blinded by the laser beam.
• Never point the laser towards people or animals and never look into the laser
yourself even if you are not standing close to the laser level.
• Protect the laser level from becoming wet and exposure to direct sunlight.
• Do not expose the laser level to extreme temperatures or changes in temperature.
Do not leave the laser level in a vehicle for a long time. Extreme temperatures or
changes in temperature can affect the precision of the laser level.
• Avoid subjecting the laser level to knocks and blows. Damage to the laser level
could affect its accuracy. The accuracy of the laser level should be tested against
known references following any heavy impact or shock.
• Switch the laser level off before transporting it. When it is switched off the levelling system
locks since otherwise there is a risk of it becoming damaged by heavy movements.
1 2
6
5
4
3
4