JB Systems Led Rainbow Bedienungsanleitung Seite 6

ENGLISH
 Use DOWN and UP buttons to change the DMX address.
 Once the correct address is shown on the display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
Channel Mode
Used to set the desired channel
setup mode.
 Press the MENU button until
"ChMd" is shown on the display.
 Press the ENTER button, the
display starts blinking.
 Use DOWN and UP buttons to
choose 1MSL, 1Ch, 7Ch or 22Ch.
 Once the desired channel setup
mode shows on the display, press
the ENTER button to save it.
To go back to the main menu without
any change press the MENU button
shortly.
Press the MENU button for about 2
seconds to exit the menu and to go
back to the normal running mode.
Show Mode
Used to choose the Show mode
when used in standalone or
master/slave mode.
 Press the MENU button until
"ShMd" is showing on the display.
 Press the ENTER button, the
display starts blinking.
 Use DOWN and UP buttons to
select one of the 8 available
shows: show1 (Sh 1) to show8 (Sh
8)
 Once the right mode shows on the
display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
Slave Mode
Used to set the projector as master or as slave unit.
 Press the MENU button until "SLMd" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "MASt" (master mode), SL 1 (normal slave mode) or SL 2 (2 light
show) mode.
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
Sound State
When the sound mode is switched ON the unit works to rhythm of the beat when used in standalone
or master/slave mode.
 Press the MENU button until "SoUn" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "On" (sound mode on) or "Off" (sound mode off).
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
JB SYSTEMS
®
4/55
OPERATION MANUAL
LED RAINBOW