English; Parent Unit - Philips AVENT SCD560 Bedienungsanleitung

EngliSh

6
introduction
Go to www.philips.com/welcome to register your product and to read the detailed user manual.
overview (Fig. 1)
1 Signal strength indicator
2 Eco Max indicator
3 Mute symbol
4 Battery status indicator
5 Navigation arrow
6 Microphone sensitivity indicator
7 Lullaby symbol
8 Nightlight symbol
9 Timer symbol
10 Temperature symbol
preparing for use
important: read the safety instructions carefully before you use the baby monitor
and keep them for future reference.
Baby unit
We advise you to use the baby unit from the mains. To guarantee automatic power backup in case
of mains failure, you can insert four 1.5V AA alkaline batteries (not included).
Do not use rechargeable batteries. The baby unit does not have a charging function and
rechargeable batteries discharge slowly when they are not in use.

parent unit

The parent unit runs on two rechargeable batteries that are supplied with the baby monitor. Charge
the parent unit before you use it for the first time and when the batteries are low.
please note that you have to charge the parent unit for the full 10 hours to have a
cordless operating time of 18 hours.
Note: When you start using the baby monitor, it takes four charge and discharge cycles before the
rechargeable batteries reach their full capacity.
using the baby monitor
positioning the baby monitor
Keep the baby unit out of the reach of the baby. Never place the baby unit inside or mount it on
the baby's bed or playpen.
- Because the cord of the baby unit presents a potential strangulation hazard, make sure that the
baby unit and its cord are at least 1 metre/3.5 feet away from your baby.
- To prevent a high-pitched sound from one or both units, make sure the parent unit is at least 1
metre/3.5 feet away from the baby unit.
linking parent unit and baby unit
1 Press and hold the 3 button on the baby unit for 2 seconds until the power light goes on.
2 Press and hold the 3 button on the parent unit for 2 seconds until the display lights up.
The 'link' light on the parent unit starts flashing red and the message 'LINKING' appears on
,
the display.
When the parent unit and baby unit are linked, the 'link' light turns solid green. The signal
,
strength indicator and the message 'LINKED' appear on the display.