Tips & Notes; Technical Data - Conrad 41 33 92 Bedienungsanleitung

Cleaning
Before cleaning the enclosure, disconnect the device from the mains voltage and
disconnect the power supply from the mains socket. The use of a dry, soft, lint-free
cloth is sufficient to clean the product.
Do not use aggressive cleaning agents as these can cause discolouration.
Do not press too strongly on the surface, to prevent scratch marks.
Dust can easily be removed using a clean, long-haired brush and a vacuum cleaner.
Tips & Notes
a) USB3.0
• USB3.0 devices are backwards compatible. This means that the hard disk enclosure,
with the SATA hard disk installed, also works with conventional USB2.0 or slower
USB1.1 ports, though only at the maximum USB2.0 or USB1.1. speed.
• Depending on the hard disk in your computer, and the hard disk installed in the
enclosure, as well as the motherboard used, USB3.0 supports speeds that may
exceed 100MByte/s!
• For USB3.0, the cable should be selected to be as short as possible to avoid a
reduction in the transfer speed.
• To connect the hard disk enclosure to a USB3.0 port on your computer, you must
use a USB3.0 cable (e.g. the one enclosed).
If you use a conventional USB2.0/1.1 cable, only the max. speed supported by
USB2.0/1.1 can be achieved and not the transmission speed supported by the
USB3.0 cable.
• If you want to connect the hard disk enclosure via a USB hub, the later must also
support the USB3.0 transfer mode, in order to achieve the maximum speed.
b) General
• The LED on the front lights up when the hard disk enclosure is switched on (Power
LED function), or it flashes during read/write access. The colour of the LED indicates
the operating mode currently active:
Blue LED: USB2.0/USB1.1
Orange LED: USB3.0
• USB devices can be plugged in and unplugged while the PC is in use.
You should, however, take into account that data may be corrupted or the operating
system may crash if the connection cable is disconnected while data are being
transferred.
In Windows, an arrow symbol is displayed in the menu bar when the hard disk (or
other USB devices) is in use. Click this arrow symbol to „separate" the device, i.e.
to terminate data transmission, so you can disconnect the connection cable without
risking the loss of data.
Disposal
Electrical and electronic products do not belong to the household waste!
Please dispose of the device when it is no longer of use, according to the
current statutory requirements.

Technical Data

a) Hard disk enclosure
Connection: ..........................................USB3.0
Suitable hard disk for installation: ........SATA, 8.89cm/3.5"
Dimensions (L x W x H): ......................Approx. 200 x 119 x 30.5mm
b) Power unit
Operating voltage: ................................100-240V~, 50-60Hz
Output:..................................................+5Vdc / 1.5A, +12Vdc / 1.5A
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.