Tips & Notes; Technical Data - Conrad 41 40 28 Bedienungsanleitung

Cleaning
Before cleaning the device, disconnect it from the USB connection. Using a dry, soft, lint-free
cloth is sufficient to clean the product.
Do not use aggressive cleaning agents as these can cause discolouration.
Do not press too strongly on the surface, to prevent scratch marks.
Dust can easily be removed using a clean, long-haired brush and a vacuum cleaner.
Tips & Notes
a) USB3.0
• USB3.0 devices are backwards compatible. This means that the hard disk enclosure, with the
SATA hard disk installed, also works with conventional USB2.0 or slower USB1.1 ports,
though only at the maximum USB2.0 or USB1.1. speed.
• In the ideal case, USB3.0 can support speeds in excess of 100MByte/s, depending on the hard
disk in your computer, the hard disk enclosure with a hard disk installed as well as the
motherboard!
• For USB3.0, the cable should be selected to be as short as possible to avoid a reduction in the
transfer speed.
• To connect the hard disk enclosure to a USB3.0 port on your computer, you must use a
USB3.0 cable (e.g. the one enclosed).
If you use a USB2.0/1.1 extension cable, only the max. speed supported by USB2.0/1.1 can
be achieved and not the transmission speed supported by USB3.0.
• If you want to connect the hard disk enclosure via a USB hub, the latter must also support the
USB3.0 transfer mode in order to achieve the maximum speed.
b) General
• The hard disk enclosure has two LEDs to indicate functioning of the USB3.0 and USB2.0/1.1
operating modes.
Blue LED indicates USB3.0 data transfer. The LED lights when there is power supplied or it
flashes during read/write access.
Green LED indicates USB2.0/1.1 data transfer. The LED lights when there is power supplied
or it flashes during read/write access.
• USB devices can be connected and disconnected during operation.
You should, however, take into account that data may be corrupted or the operating system
may crash if the connection cable is disconnected while data are being transferred.
In Windows, an arrow symbol is displayed in the menu bar when the hard disk (or other USB
devices) is in operation. Click this arrow symbol to "separate" the device, i.e. to terminate data
transmission, so you can disconnect the connection cable without risking the loss of data.
• If you have inserted a USB3.0 plug-in card in your computer (e.g. if your motherboard does not
equipped with a USB3.0 port), you must check whether the plug-in card has its own power
connection. If available, it must be connected to the PC power supply unit; otherwise the
USB3.0 port will not function correctly, or too little current will be supplied to enable the hard
disk enclosure with a hard disk installed drive to function.
Disposal
Electrical and electronic products do not belong in the household waste!
Please dispose of the device when it is no longer of use, according to the current
statutory requirements.

Technical Data

Connection: ..........................................USB3.0
Suitable hard disk for installation: ........SATA, 6.35cm/2.5", installation height 9.5mm
Dimensions (L x W x H): ......................Approx. 130 x 82 x 13mm (without rubber feet)
Weight: ................................................approx. 81g
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.