I) Cueing; Loop Function - Renkforce SCDJ-350USB Betriebsanleitung

i) Cueing

You can select the starting point for playback using the CUE-function. The starting point is set automatically
(AUTO CUE).
The advantage of this function is that e.g. mute time at the start of a track is not played back and
that there are therefore no breaks after starting the playback.
Auto CUE
• The device will set the cue point automatically where the music starts after the track selection or at the
beginning of a new track during playback.
Back CUE
• During playback, push the CUE button (13).
• The player returns to where playback was started and pauses.
Checking the CUE mark
• Press the CUE button (13).
• The device returns to the CUE mark and pauses.
• Hold down the CUE button (13).
• The music is played from the CUE mark as long as you hold down the CUE (13) button.
• When the button is released, the player returns to the CUE mark and pauses.
Deleting a CUE mark
• The CUE mark is deleted once a new CUE mark is set.
Manual setting of the CUE mark
• To set the CUE mark manually, you have to switch from playback to pause mode at the desired position
of the track. For this, push the PLAY/PAUSE button (12) during playback. Precise setting is possible with
the JOG wheel (14) and the SEARCH buttons (25). The starting position of the track is automatically saved
as new CUE mark.
j) LOOP Function
You can define a playback loop.
• At the desired starting point of the playback loop, push the IN button (20).
• At the desired end point of the playback loop, push the OUT button (21).
• The playback loop is now played continuously until the OUT button (21) is pressed again.
• To start a saved playback loop, push the RELOOP button (22).
The existing playback loop is deleted when a new playback loop is programmed.
42