Setting The Operating Mode; Manual Operation - Conrad Octopod 75 Strobe FX Bedienungsanleitung

Setting the Operating Mode

The effect spotlight has 4 modes of operation:
•

Manual operation

This mode allows the brightness of the individual light colours to be adjusted using the DIP switch (4).
• Control via the Inbuilt Controller
There are 2 programmes available. The cycle speed and the flash speed can be adjusted.
• Master-slave operation
This mode allows a light effect to be defined as the master, whose inbuilt controller controls the slave light effects.
All light effects of a master slave chain then run synchronously. However, only the same type of devices can be
connected with one another in this operating mode.
• DMX mode
In this mode the lighting effect is controlled by the external DMX controller.
The setting of the operating mode is carried out via the DIP switch (4) on the back of the device.
Manual operation
• Move the DIP switches 10, 11 and 12 to OFF.
Octopod 75 Strobe FX Model:
• Use the DIP switches 1, 2, 3 and 4 to set the brightness of the ultraviolet colour. The more DIP switches are set
to ON, the brighter the colour is.
• Use the DIP switches 5, 6, 7 and 8 to set the brightness of the white colour. The more DIP switches are set to
ON, the brighter the colour is.
Octopod 75 Strobe LED Spot Model:
• Use the DIP switches 1, 2 and 3 to set the brightness of the red colour. The more DIP switches are set to ON,
the brighter the colour is.
• Use the DIP switches 4, 5 and 6 to set the brightness of the green colour. The more DIP switches are set to ON,
the brighter the colour is.
• Use the DIP switches 7, 8 and 9 to set the brightness of the blue colour. The more DIP switches are set to ON,
the brighter the colour is.
24