Parrot ASTEROID Tablet Betriebsanleitung Seite 16

particular vehicle safety device such as airbags and
other SRS systems.
Installing the USB cables
Connect the USB cables to the Parrot ASTEROID
Tablet. We recommend you connect all audio
cables to the Parrot ASTEROID Tablet even if you
do not plan on using them. Route the audio cables
to a suitable location in your vehicle such as the
glove box or arm rest compartment. It may be
necessary to drill a hole in your dashboard to do
so. Avoid using USB extension cables.
Make sure you connect the iPod / iPhone cable to
its specific USB port. "iPod" is written above it.
To guarantee an optimal reception quality we
recommend you do not connect your internet
USB key 3G on the Parrot ASTEROID Tablet
directly : use the USB cable to install your device
on the dashboard (or any other open area).
Installing the screen
Warning: Avoid any installation which could
hinder the use of any important command or
hinder the driver's visibility. Do not install the
Parrot ASTEROID Tablet in the airbag deployment
area or in a possible head impact area. Make sure it
is not exposed to the air stream from air vents.
The craddle can be mounted on the windscreen or
on the circular part which is to be stuck on the
16 16 English
dashboard.
To make sure the adhesive tape adheres well :
clean the area with an appropriate cleaning
product before sticking the support ;
once you have stuck the support on the
dashboard, wait for approximately 2 hours
without handling it.
To mount the craddle, clean the selected location
and press the suction cup against the windscreen
or the circular part and lift the locking lever until
the mounting kit is correctly fixed (diagram B p.9)
.
The cooling and heating cycle inside your vehicle
may cause the suction cup to detach from the
windscreen. Make sure the suction cup is
properly affixed to the windscreen each time you
use the Parrot ASTEROID Tablet. If it is not the
case, the device may fall whilst driving. Clean the
windscreen and reinstall the suction cup if
necessary.
Install the screen on the mounting kit starting
with its lower magnetic part.
Remember to remove your screen when leaving
the vehicle to avoid tempting any would-be
thieves and to prevent prolonged exposure to
sunlight. Lift the lever located above the screen
to remove it from the craddle. (diagram C p.9).
Installing the remote control
Install the remote control on the steering wheel
(diagram D p.10) or stick it on the dashboard using
the second support. Do not install the remote
control on the outside of the steering wheel and
ensure it does not get in the way when driving
(diagram F p.10).
Make sure it is securely attached, so that it does
not move when you are driving.
Note: The remote control only works with a 3V
CR2032 battery. Make sure the battery is correctly
positioned before inserting it into the remote
control (diagram E p.10).