Conrad 67 22 90 Bedienungsanleitung Seite 3

O P E R A T I N G I N S T R U C T I O N S
LED Wristwatch
Item-No. 67 22 90
Intended Use
This LED wristwatch is for displaying the time as well as the date in red LED numerals.
Yellow LEDs indicate whether you have the "Time" or "Date" displayed. The 12-hour format, with
the indications "AM" for 0-12 o'clock and "PM" for 12-24 o'clock, is displayed with green LEDs.
The watch is waterproof up to 3 ATM.
Any use other than described above is not permitted and can damage the product. The product
may not be altered or converted.
All the safety and operating instructions in this manual must be followed carefully. Please read
the entire operating manual before using the product. Always retain it for later reference.
Explanation of the Symbols
The exclamation mark in a triangle indicates a particular risk during handling,
operation and control.
The "Hand" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for damage to pro-
perty and injury to persons caused by mishandling or non-compliance with the
safety instructions! The product may not be altered or converted. In such
cases the warranty will be null and void.
General Safety Instructions
• If you have any doubts about the correct operation, or the safety of the device,
please consult a specialist.
• The product is not a toy and must be kept out of the reach of children.
• Do not leave packing materials unattended. They may become dangerous
playthings for children.
• If you sell this product or give it away, you must hand over these operating
instructions.
• Please observe the additional safety instructions in the individual chapters of this
manual.
• Maintenance, adjustment and repair may only be carried out by a specialist or a
specialised repair shop.
• If you have any questions, which are not answered in this manual, please contact
our technical customer service.
Product Specific Safety Instructions
• This product must not be exposed to high mechanical pressure.
• Falls from a low height can damage the product.
• This product must not be exposed to extreme temperatures, strong vibrations,
moisture or heavy mechanical stress.
• After rapid changes in temperature, the product requires some time to adjust to the
surrounding temperature. Wait until the components have adjusted to the ambient
temperature before use.
• If safe operation is no longer possible, take the device out of service and secure it
against unintended use.
Battery Safety Information
• Make sure that the polarity is correct when inserting the batteries.
• Remove the batteries, if you are not going to use the device for a while, to prevent
damage from leaking.
• Leaking or damaged batteries/rechargeable batteries can cause acid burns on
contact with the skin. Therefore, you should wear protective gloves when handling
damaged batteries/rechargeable batteries.
• Do not leave batteries/rechargeable batteries lying around; they could be
swallowed by children or pets. If swallowed, consult a doctor immediately.
• Ensure that batteries/rechargeable batteries are not short-circuited or thrown into
a fire. There is a risk of explosion!
• For the environmentally friendly disposal of batteries/rechargeable batteries,
please read the chapter "Disposal".
Initial Start-Up
When delivered, the watch is in the so-called "sleeping mode".
Press any key to turn the display on.
Setting the Time and Date
www.conrad.com
• Press either the "ADJ" or the "MODE" key, to turn the time display on.
• Keep the "MODE" key pressed for about 2 seconds, until "TIME" (1) is displayed and the left
row of numbers (2) for setting the hours flash at the same time.
Version 02/11
• Keep the "ADJ" key pressed, until you have set the correct hours. Please bear in mind whether
you want to set "AM" or "PM" (7).
• Press the "MODE" key again. "Time" (1), and the right row of numbers (4) for setting the
minutes, flash at the same time.
• Keep the "ADJ" key pressed, until you have set the correct minutes.
• Press the "MODE" key again. "Date" (3), and the left row of numbers (2) for setting the month,
flash at the same time.
• Keep the "ADJ" key pressed, until you have set the correct month.
• Press the "MODE" key again. "Date" (3), and the right row of numbers (4) for setting the day,
flash at the same time.
• Keep the "ADJ" key pressed, until you have set the correct day.
• Press the "MODE" key, to return to the time display. All settings are now confirmed.
Product view
Explanation of the Display
1. "Time" for setting the displayed time
2. Display field for displaying hours and month
3. "Date" for setting the date displayed
4. Display field for displayed minutes and days
5. "MODE" key for making adjustments and confirmation
6. "ADJ" key for setting the hours, minutes, month and day
7. Display field for "AM" or "PM"
Displaying Time and Date
• Press any key, to turn the display on.
• The hours are shown in the left display field (2), the minutes are shown in ten's and one's
positions in the right display field (4). The minutes have to be added. The field, "Time" (1),
flashes at the same time.
Please remember the settings for "AM" for 0-12 o'clock and "PM" for 12-24 o'clock in field (7).
• If you press the "Mode" key, while the time is displayed, the date will be shown.
• The month is shown in the left display field (2), the day is shown in ten's and one's positions
in the right display field (4). The numbers have to be added. The field, "Date" (3), flashes at the
same time.
Maintenance and Cleaning
• To clean the watch, a dry, soft and clean cloth is sufficient. For heavier soiling of the exterior,
you can moisten the cloth slightly with lukewarm water.
• Clean the watch very carefully, otherwise you may scratch it. Do not press too strongly on the
glass cover as this may cause scratch marks.
• Never use aggressive cleaning agents or chemicals since these will damage the watch.
Note on Water Tightness
The watch is waterproof up to 3 ATM.
Explanation of water tightness according to DIN 8310
Please note that the setting menu will be exited automatically if no keystroke is per-
formed for 30 seconds.
The display background light is lit for about 10 seconds, before switching off auto-
matically.
Please note that the specification for the water tightness refers to a new watch it is
not a permanent feature. The the sealing elements' built-in function may deteriorate
during daily use.
The weak points of waterproof watches are the glass, the crown, the casing bottom
or even the construction of the casing.
Please note that vigorous movements during swimming or jumping into water may
result in brief pressure peaks.