Safety Instructions - Conrad Neoclassic Bedienungsanleitung

O P E R A T I N G I N S T R U C T I O N S
Neoclassic LED Wrist Watch
Item-No. 67 20 18
Intended use
This wrist watch features an AR (anti-reflection) coated display, a metal housing and
a watchstrap made of genuine leather.
The time is shown on the display via red dot-matrix digits. The time can be indicated
in 12 or 24 hour indicating format.
With these features, this high-quality designer watch sets accents and highlights, and
is a real „eye-catcher".
The watch must not get damp or wet.
Any use other than that described above could lead to damage to this product and
involves the risk of short circuits, fire, electric shock, etc. The safety instructions must
be followed at all times. No part of the product should be modified or reassembled.
The safety instructions are to be observed without fail!
Explanation of the symbols
A lightning-bolt symbol in a triangle indicates a health hazard, e.g. danger
of electric shock.
The exclamation mark in a triangle indicates a particular risk during hand-
ling, operation and control.
The „Hand" symbol indicates special tips and operating information.

Safety instructions

The warranty will be void in the event of damage caused by failure to
observe these safety instructions! We do not assume liability for
consequential damage!
We do not accept any liability for personal injury or damage to property
caused by incorrect handling or non-observance of the safety
instructions. The warranty will be void in such cases.
• The product must not be modified or converted, as not only the CE
approval will become void but also the warranty.
• Do not touch leaking or oxidised batteries with your bare hands. Use
protective gloves.
• The radio controlled watch should not be exposed to extreme tem-
peratures, direct sunlight, intense vibrations or heavy mechanical
stress.
• After rapid changes in temperature, the product requires some time to
adjust to the surrounding temperature. Wait until the components
have adjusted to the ambient temperature before use.
• This product is not a toy and should be kept out of the reach of chil-
dren!
• Should you have any doubts regarding the correct use of the product
or safety, please contact an expert!
• Never leave the packaging material lying around unattended. Plastic
film/bags etc. can be dangerous playthings for children, there is a
risk of suffocation.
• If you have reason to assume that safe operation is no longer possible,
disconnect the device immediately and secure it against inadvertent
operation.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device does not function any longer and
- if the device was stored under unfavourable conditions for a long
period of time
or
- it has been subjected to considerable stress during transportation.
• In commercial institutions, the accident prevention regulations of the
Employer's Liability Insurance Association for electrical systems
and operating materials are to be observed.
• The watch must not get damp or wet.
• The voltage is supplied via 1 x 3V coin cells (type: CR2032).
• Ensure that no sources of magnetism or electro-magnetism or heat
sources are in the vicinity of the product.
• Do not expose the product to strong mechanical stress. Falls from
low heights and pressure can damage the device.
• Never pour fluids out above electrical devices.
• Maintenance, adjustment and repair work may only be carried out by a
qualified expert or a specialist workshop.
• For any unanswered questions please contact our customer service
or other specialists.
Battery notes
www.conrad.com
• Batteries should be kept out of children's reach.
• Please observe the correct polarity (plus/+ and minus/-) when inserting the battery.
Version 08/09
• Do not leave batteries lying around in the open; there is a risk of them being
swallowed by children or domestic animals. If swallowed, consult a doctor imme-
diately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use
suitable protective gloves.
• Make sure that the battery is neither short-circuited nor thrown into a fire. There is a
risk of explosion!
• Do not recharge normal batteries. Explosion risk! Only charge rechargeable
batteries which are intended for this purpose; use a suitable battery charger.
• If the product is not to be used for a longer period (e.g. storage), remove the battery.
Old batteries may leak and cause damage to the product, which will lead to the loss
of the warranty/guarantee.
• For the environmentally friendly disposal of batteries and rechargeable batteries,
please read the chapter „Disposal".
Product View
Initial Start Up
When delivered, the watch is in the so-called „sleeping mode".
• Press any key.
Setting the time format, time, year, month, day
• Press and hold the keys „MODE", „SET" and „ADJ" for approx. 1 second. Following
that, the time will be displayed.
• Press and hold the „SET" button for approx. 2 seconds. 12H or 24H will be displayed
(= time display 12 hours-format or 24 hours-format).
• Press the „ADJ" key to set the desired time format.
• Press the "SET" button. The display of the current hour flashes.
• Set the current hour using the „ADJ" button.
• Press the "SET" button. The display of the current minutes flashes.
• Set the current minute using the „ADJ" button.
• Press the "SET" button. The year display flashes.
• Set the current year using the „ADJ" button.
• Press the "SET" button. The month display flashes.
• Set the current month using the „ADJ" button.
• Press the "SET" button. The day display flashes.
• Set the current day using the „ADJ" button.
• Press the „SET" key to save the settings.
Press the „MODE" button during programming to exit the setting
menu without saving.
Please note that the setting menu will be exited automatically if no
keystroke is performed for 10 seconds.