Model Description; Specification - GRAUPNER BAZILLUS Betriebsanleitung

Operating instructions for the BAZILLUS model boat, Order No. 8609

Model description


Ready-made model (RTR)

2.4 GHz Frequency Hopping RC system, allowing several models to be operated simultaneously

Strong plastic hull and deck, factory-joined

SPEED 320 electric motor and surface-piercing propeller

Stainless steel drive shaft

Adjustable turn-fins

Water-cooled motor, rudder pushrod sealed by rubber bellows

Sealed watertight receiver, rudder servo electronics and electronic speed controller, already installed

Set contents: hull and deck, already joined, cockpit cover with supplementary hatch cover, motor, propel-
ler shaft, rudder system, turn-fins, boatstand, decals (already applied), small items, drive battery, charger

Specification

Overall length approx.
Hull length, approx.
Beam approx.
All-up weight approx.
Manufacturer's declaration from Graupner GmbH & Co. KG,
Content of the manufacturer's declaration
If material defects or manufacturing faults should arise in a product distributed by us in the Federal Republic
of Germany and purchased by a consumer (§ 13 BGB), we, Graupner GmbH & Co. KG, D-73230
Kirchheim/Teck, Germany, acknowledge the obligation to correct those defects within the limitations de-
scribed below.
The consumer is not entitled to exploit this manufacturer's declaration if the failure in the usability of the
product is due to natural wear, use under competition conditions, incompetent or improper use (including
incorrect installation) or external influences.
This manufacturer's declaration does not affect the consumer's legal or contractual rights regarding defects
arising from the purchase contract between the consumer and the vendor (dealer).
Extent of the guarantee
If a claim is made under guarantee, we undertake at our discretion to repair or replace the defective goods.
We will not consider supplementary claims, especially for reimbursement of costs relating to the defect (e.g.
installation / removal costs) and compensation for consequent damages unless they are allowed by statute.
This does not affect claims based on legal regulations, especially according to product liability law.
Guarantee requirements
The purchaser is required to make the guarantee claim in writing, and must enclose original proof of pur-
chase (e.g. invoice, receipt, delivery note) and this guarantee card. The purchaser must send the defective
goods to us at his own cost, using the following address:
The purchaser should state the material defect or manufacturing fault, or the symptoms of the fault, in as
accurate a manner as possible, so that we can check if our guarantee obligation is applicable.
The goods are transported from the consumer to us and from us to the consumer at the risk of the con-
sumer.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical modifications reserved.
270 mm
230 mm
70 mm
172 g
Brunel Drive, Newark, Nottinghamshire, NG242EG
Gliders
1
01/2011