LaserLiner ThermoCamera-Vision Bedienungsanleitung Seite 41

13.1
Area measurement / function
Area 1
Area 2
Area 3
13.2
Area measurement / parameters
For each measurement point, you can either use the previously set general parameters (see chapter 8)
or de ne different parameters.
Area 1
Area 2
Area 3
! To set values that deviate from the general parameters, deactivate the check for
the general parameters in this menu.
13.3
Measurement points / symbols
Once activated, the respective measuring areas appear on the display. The prede ned measurement points
appear within the measuring area using the symbols listed below. For each measurement point within the
measuring area, the temperature is displayed in the prede ned measurement unit on the top left.
A1H: 75.2
A1L: 73.8
A1A: 74.7
1
ThermoCamera-Vision
Mode Area 1
Max
Min
Avg
Area Setting 1
Use global para
Emiss: 0.93
Distan:
2 m
Offset:
0.0 °C
A1 H Area 1 maximum temperature (red)
A1 L Area 1 minimum temperature (green)
A1 A Area 1 average temperature
activated
activated
Max.
Min.
Avg
Area Setting 1
Use global para
Emiss: 0.93
Distan:
2 m
Offset:
0.0 °C
de-
GB 41