Installation; Operation - Renkforce 1071011 Bedienungsanleitung

G Operating Instructions
Dummy Dome Camera with IR Simulation
Item no. 1071011
Intended use
The product looks deceptively similar to a functional surveillance camera, and there-
fore, it can be used for deterrence in secluded or critical areas (e.g., driveways,
entrance areas, shops, etc.).
The dummy camera is designed for installation and use indoors; it must not get wet
or damp.
The power supply for the dummy dome camera is via 2 batteries of type AA/Mignon
(not included, available separately).
The weak lighting of the LEDs in the night simulates a function of the camera.
Always observe the safety instructions and all other information included in these
operating instructions.
This product complies with the applicable national and European requirements. All
names of companies and products are the trademarks of the respective owners. All
rights reserved.
Contents
• Dummy dome camera
• Assembly material
• Operating instruction
Explanation of the symbols
This symbol indicates specific risks associated with handling, function and
use.
The "arrow" symbol indicates special tips and operating information.
Safety Instructions
T he warranty will be void in the event of damage caused by failure to ob-
serve these safety instructions! We do not assume any liability for any re-
sulting damage!
W e shall not accept liability for damage to property or personal injury
caused by incorrect handling or non-compliance with the safety instruc-
tions. In such cases, the warranty will be null and void.
• The unauthorised conversion and/or modification of the product is not
permitted for safety and approval reasons (CE). Do not open/disassemble!
Contains no customer-serviceable parts.
• The product should be used only in dry indoor areas; it must not get wet or
damp.
• The product is not a toy and must be kept out of the reach of children.
Install and use the product where it is out of the reach of children.
• Do not operate the device in environments where there are high levels of
dust, flammable gases, vapours or solvents. There is a danger of fire and
explosion!
• Do not carelessly leave the packaging material lying around since this
may become a dangerous toy for children.
• Handle the product with care; it may be damaged by impacts, blows, or
accidental falls, even from a low height.
Battery and accumulator instructions
• Batteries/rechargeable batteries must be kept out of the reach of children.
• Do not let batteries/rechargeable batteries lie around openly. There is a risk of bat-
teries being swallowed by children or pets. If they are swallowed, consult a doctor
immediately.
• Leaking or damaged batteries/rechargeable batteries may cause acid burns when
coming into contact with skin, therefore use suitable protective gloves.
Liquids leaking from batteries/rechargeable batteries are very chemically aggres-
sive. Objects or surfaces coming into contact with these liquids might be consider-
ably damaged. Thus, store batteries/rechargeable batteries in a suitable location.
• Normal/rechargeable batteries must not be short-circuited, opened or thrown into a
fire. There is a risk of explosion!
• Do not recharge normal, non-rechargeable batteries, due to risk of explosion! Only
charge rechargeable batteries that are intended for this purpose; use a suitable
battery charger.
• Never mix standard batteries with rechargeable batteries, use either standard bat-
teries or rechargeable batteries.
• Do not mix batteries/rechargeable batteries with different charge levels (e.g., full
and half-full batteries/rechargeable batteries).
• Always replace the complete set of batteries/rechargeable batteries.
• Check that the polarity is correct when inserting the batteries/rechargeable batter-
ies (pay attention to plus/+ and minus/-).
• If you wish to use rechargeable batteries, please note that, due to the lower output
voltage (batteries = 1.5 V, rechargeable batteries =1.2 V), the operating time will
decrease.
Therefore, we recommend that you use high-quality alkaline batteries to operate the
dummy dome camera in order to ensure long-lasting and reliable operation.

Installation

• Select a suitable mounting location for the dummy dome camera. During installa-
tion, keep the desired alignment of the camera opening in mind.
Using the hinge in the bracket, the dummy dome camera can be mounted on a room
ceiling or even on a wall or something similar.
Adjust the hinge accordingly and screw it in place.
• Attach the dummy dome camera to the ceiling or a wall. Use screws and plugs that
are suitable for the surface.
Please make sure that existing cables or wiring not damaged when drilling/screw-
ing into place.
Inserting/replacing the batteries
• Open the dummy dome camera by slightly turning the front part counter-clock-
wise. Insert two AA batteries with the correct polarity (pay attention to plus/+ and
minus/-).
• Close the dummy dome camera again.
• A battery change is necessary when the LEDs no longer light up at night.

Operation

The LEDs of the dummy dome camera are controlled by a brightness sensor and come
on only when it is dark, to save power.
The weak reddish lighting of the LEDs in the night simulates a function of the camera.
Maintenance and cleaning
Maintenance or repair may be performed only by qualified personnel or a specialised
repair shop. The product contains no parts that require servicing. Therefore, do not
open/dismantle it (except to replace the batteries).
Use a clean, dry, soft cloth for cleaning. Do not apply too much pressure on the hous-
ing (especially the transparent cover); this could result in scratch marks.
Do not use abrasive cleaning agents, cleaning alcohol or other chemical solutions,
since these could damage the housing or even impair operation.