Safety Notes; Functions; Notes On Digital Operation; General Notes - Märklin ML 3000 C‘C‘ Bedienungsanleitung

Safety Notes

• This locomotive is only to be used with the operating
system it is designed for.
• This locomotive must not be supplied with power simulta-
neously by more than one power source.
• Pay close attention to the safety notes in the instructions
for your operating system.

Functions

• Built-in electronic circuit for operation with an conventio-
nal DC power pack, Trix Selectrix or NMRA DCC digital.
• Triple headlights in the front, dual white marker lights in
the rear that change over with the direction of travel.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX)
and DCC.
• The full range of functions is only available under DCC.
• Analog 14 volts DC, digital 22 volts AC.

Notes on digital operation

• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed
once in this digital system.
• This locomotive comes from the factory programmed for
the digital address „01" (Selectrix) / „03" (DCC).
• This locomotive with the settings made at the factory can-
not be operated with opposed polarity DC power in braking
track blocks. If this feature is desired, then you must do
without conventional DC operation (CV 29 / Bit 2=0).
8
• Function:
Headlights
Operating Sounds
Horn (long blast))
Coupler Sounds
Horn (short blast)

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where parts neither
manufactured nor approved by Trix have been installed in Trix products or where Trix
products have been converted in such a way that the non-Trix parts or the conver-
sion were causal to the defects and / or damage arising. The burden of presenting
evidence and the burden of proof thereof, that the installation of non-Trix parts or
the conversion in or of Trix products was not causal to the defects and / or damage
arising, is borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
SX1 DCC
Head-
F0
lights
Func. F1
– F2
– F3
– F4