Establishing A Connection To The Workpiece; Mounting The Welding Torch; Filling The Cooling Unit - Fronius MagicWave 2200 Bedienungsanleitung

Connecting up When using a TIG welding torch with an integral gas connector:
the gas cylinder -
(continued)
-
When using a TIG welding torch with no integral gas connector:
-
Establishing a -
connection to the -
workpiece
-
Mounting the -
welding torch -
-
Important! Instead of a control plug, the JobMaster TIG welding torch has a plug for
the standardised LocalNet connection socket (18).
-
-
When using a TIG welding torch with an integral gas connector:
-
-
When using a TIG welding torch with no integral gas connector:
-
Only when using a water-cooled torch and cooling unit:
-
Filling the Important! The cooling unit is supplied "dry", i.e. without any coolant in the reservoir.
cooling unit The coolant is supplied separately in a 5l canister. Before using the cooling unit for the
first time, fill the reservoir with coolant!
As Fronius has no influence on factors such as the purity and filling-level of the coolant,
no warranty is given for the coolant pump.
Only fill or top up the reservoir of the cooling unit with original Fronius coolant
(40,0009,0046). The electrical conductivity and inadequate compatibility of all other
antifreeze agents makes them unsuitable for use here.
-
On the rear of the power source, connect the pressure regulator to the Shielding
gas connection socket (22) by means of the gas hose
Tighten the swivel nut
Connect the gas hose to the pressure regulator
Shift the mains switch into the "0" position
Plug the grounding (earthing) cable into the "plus" current socket (17) and twist it to
fasten it
With the other end of the grounding (earthing) cable, establish a connection to the
workpiece
Shift the mains switch into the "0FF" position
Plug the welding cable of the TIG torch into the "minus" current socket (16) and
twist it clockwise to latch it into place
Plug the control plug of the welding torch onto the torch control connection (19) and
twist it to fasten it
Connect up the JobMaster TIG welding torch to the LocalNet connection socket
(18)
Tool up the welding torch (see the instruction manual for the torch)
On the rear of the power source, connect the pressure regulator to the Shielding
gas connection socket (22) by means of the gas hose
Tighten the swivel nut
Connect the gas hose to the pressure regulator
Plug in the welding-torch water connectors to the water forward-flow (27 - black)
and return-flow (28 - red) connections on the cooling unit.
Filling or topping up with coolant:
- Shift the mains switch into the "0" position
- Unscrew the screw cap (26)
- Fill / top up the reservoir with coolant
- Screw the cap (26) back on again - the cooling unit is now ready for operation
25