Flight Control - Revell Control 01015 Benutzerhandbuch

6B If the helicopter quickly or slowly rotates anti-clockwise by itself...
If the helicopter begins to automatically rotate anti­clockwise, rotate the trim
adjustment (2D) clockwise until the helicopter no longer rotates on its own.
Note: Only minimal corrections of the controls are necessary for a smoothing flying
behaviour of the helicopter!
7A Take off or increase altitude by carefully moving the thrust controller (2B)
forward.
7B Land or decrease altitude by moving the thrust controller (2B) backward. Only
minimal corrections to the controller are necessary to ensure smoothing flying
of the helicopter!
7C Fly forward by moving the controller for forward/backward flight and right/
left rotation (2E) carefully forward.
7D Fly backward by moving the controller for forward/backward flight and right/
left rotation (2E) carefully backward.
7E Turn the helicopter around anti­clockwise by moving the controller for forward/
backward flight and right/left rotation (2E) to the left.
7F Turn the helicopter around clockwise by moving the controller for forward/
backward flight and right/left rotation (2E) to the right.
7G Use button (2F) to switch the LED in the fuselage on and off.
7H Briefly press the button for (2G) to fly more quickly. Press the button again
briefly to return to normal flying mode.
GENERAL FLYING TIPS:
• Always place the helicopter on a level surface. An inclined surface can, under
certain circumstances, negatively effect the helicopter during take­off.
• Always operate the controls slowly and with a gentle touch.
• Always maintain visual contact with the helicopter and do not look at the remote
control!
• Move the thrust controller somewhat down again once the helicopter has lifted
off from the ground. Maintain flying altitude by adjusting the thrust controller.
• If the helicopter descends, move the thrust controller slightly upward again.
• If the helicopter climbs, move the
thrust controller down slightly.
• To fly along a curve, tapping the Controller for forwards and backwards flight as
well as rotation very slightly in the respective direction often suffices. There is a
general tendency during preliminary attempts at flight to operate the helicopter's
controls too aggressively. Always operate the controls slowly and carefully. Never
fast and fitfully.
• Beginners should first master trimming before attempting to master the thrust
controller. It is not necessary for the helicopter to fly straight at first. It is far more
important to maintain a constant height of approximately one metre above the
ground by repeatedly tapping the thrust controller. Only then should the pilot
practise steering the helicopter left and right.
14

7 FLIGHT CONTROL

INSTRUCTIONS FOR SAFE FLYING