VOLTCRAFT PLC3000 Bedienungsanleitung Seite 34

d) Setting options and consumption display
• Tap on the field right next to the on/off switch
control view of your energy costs meter. Here you can find the following
functions:
Program timer, countdown timer, random timer (random switching),
overload protection and energy-saving stand-by mode.
Program timer
Use the program timer to set the power-on/power-off times of the connected
device (consumer). Tap on the field >new appointment< with the
to set the program timer. The program timer can be set to the minute for
each single weekday or for multiple weekdays. The program timer can be
switched on or off.
Countdown timer
Use the countdown timer to set a power-on/power-off time when the device
is turned on. Select a power-on/power-off time between 1 minute and
23 hours and 59 minutes. Tap on the switch symbol in the "Function" field
to select power-on or power-off. Then tap on >Start timer< to save your
settings. The display will indicate the selected function with "ON" or "OFF".
The display of your mobile device will show the remaining time until the
device powers on or off. When the pre-set time has elapsed, the power
supply connects or disconnects automatically.
Random timer
Use the random timer to swicth the connected load on or off at random
times.
Overload protection
Set an overload protection of up to 3699 watts. You may also set the
measurements the product performs in case of overload. You may select
"Auto Cut Off" and "Buzzer Alert". An acoustic signal will sound when the
"Buzzer Alert" gets activated. Then press the on/off switch (6) to turn off the
acoustic signal. Switch off the connected electric device after the overload
has been triggered and disconnect the power plug of your electric device
from the isolated ground receptacle (1) of the energy costs meter.
34
/ to navigate to the
icon