Inhaltsverzeichnis
Werbung
blade before placing saw down on bench or floor.
An unprotected, coasting blade will cause the saw to
walk backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop after
switch is released.
■
Wear eye and ear protection.
■
Wear dust mask.
■
Do not use any abrasive wheels.
■
Avoid overheating the blade tips. Do not use dull or
damaged blades. Do not force the tool.
■
Only use saw blades recommended.
■
Do not use blades of larger or smaller diameter than
recommended.
LASER SAFETY
■
Do not stare into beam during operation.
■
Do not project the laser beam directly into the eyes of
others. Serious eye injury could result.
■
Do not place the laser in a position that may cause
anyone to stare into the laser beam intentionally or
unintentionally.
■
Do not use optical tools to view the laser beam.
■
Do not operate the laser around children or allow
children to operate the laser.
■
Do not attempt to repair the laser device by yourself.
■
Do not attempt to change any parts of the laser device
by yourself.
■
Any repairs must only be carried out by the laser
manufacturer or authorized service agent.
■
Do not replace the laser with a different type.
INTENDED USE
■
Sawing and mitre cutting all types of wood.
Do not use for cutting metal or masonry.
MAINTENANCE
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
■
When servicing, use only identical Ryobi replacement
2
WARNING
WARNING
parts. Use of any other parts may create a hazard or
cause product damage.
■
Be sure to disconnect the tool from the power supply
before attaching or removing the saw blade. Clean the
tool and guarding system with clean cloths, or blow it
clean with compressed air.
■
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
■
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
■
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorized service
center to avoid risk. Contact authorized service center.
■
For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and
packaging
environmental-friendly recycling.
SYMBOLS
Safety alert
Wood
Do not cut metals
Wear ear protection
Wear eye protection
Laser radiation.
Do not stare into beam.
Class 2 laser product
λ: 650nm; P≤1mW
EN 60825-1:2007
English
should
be
sorted
for
Werbung
Inhaltsverzeichnis
