Intermediate positions for roller shutters / awnings /
venetian blinds
Roller shutter
Pos
Intermediate
position
Pos
Ventilation
position
Programming the intermediate position in the receiver
Requirement
The transmitter/transmitter channel has been programmed. The end
positions of the drive have been set. The blind is at its upper end
position.
1. Move the blind to the required position with the DOWN button.
Keep pressing the DOWN button.
2. In addition press the STOP button. The blind will stop. The
status display lights up briefly.
The intermediate position is programmed.
Programming the ventilation/tilting position in the
receiver
Requirement
The transmitter/transmitter channel has been programmed. The end
positions of the drive have been set. The blind is at its lowest end
position.
1. Use the UP button to move the blind UP until the ventilation
gaps open or the slats are inverted. Keep pressing the UP
button while it is moving.
2. In addition press the STOP button. The blind will stop. The
status display lights up briefly.
The ventilation/tilting position is programmed.
Awning
Intermediate
position
--/fabric
tensioning
www.elero.com
Venetian blind
Intermediate
position
Tilting position
GB-23