elero TempoTel 282670001 Bedienungsanleitung Seite 39

If the hand-held transmitter has two or more bidirectional individual
channels, you can configure and select two group control systems
by moving the joystick briefly to the right. You can allocate the
bidirectional channels to a group via the "Administration" menu.
Selection button
Pressing the select button briefly allows you to query the current
status (automatic/manual) of the programmed receiver (bidirectional
receivers only) and the hand-held transmitter.
Pressing the select button for longer (approx. 1 second) switches
off automatic mode in an individual channel. The operating mode
display lights up red and changes to MANUAL mode in the display.
 The receiver now carries out manual movement commands only
and does not respond to automatic movement commands.
NOTE
In unidirectional channels only the automatic system for timed
switching functions is switched off when these are in manual mode.
This means the receiver does not respond to automatic timed
switching commands. The automatic shading system stays
switched on in unidirectional receivers.
In bidirectional channels all the automatic functions in the
receivers are switched off in manual mode. This means the receiver
does not respond to automatic timed switching commands and
shading commands from programmed sensors.
Pressing the selection button for longer (approx. 1 second at the
most) switches on automatic mode in the relevant individual
channel once again. The operating mode display lights up green
and changes to AUTO mode in the display.  The receiver now
executes automatic and manual travel commands.
Pressing the selection button in the central channel for longer
(approx. 1 second at the most) changes the AUTO or MANUAL
operating mode for all the individual channels. Switching all the
channels to AUTO operating mode sets a different operating mode
for individual channels (AUTO and MANUAL),as indicated by the
orange operating mode display and the letters A+M in the display.
www.elero.com GB-11