Status Display - elero TempoTel 282670001 Bedienungsanleitung

Status display

A radio signal is displayed by the illumination of the status display
(LED ring around the STOP button). The status display can show
different colours:
Orange
Flashing
orange
Quick flashing
orange
Green
Green
Red
The transmitting power or the radio range will be reduced through
the reduction in the performance of the battery. If the status display
no longer lights up when you press a button, you must replace the
batteries. ( see battery replacement)
Group control unit
A group is understood to mean the control of several receivers at
the same time. The selected group is controlled by a travel
command.
You can program any number of receivers in each channel.
You can use all the radio channels to control several receivers. The
central channel (channel selection "All" in display) controls all radio
channels at the same time.
Joystick
Pressing the joystick briefly up and down enables you to select from
10 channels. The channels are indicated by channel number in the
display.
An additional channel is reserved for the central command, to which
all the individual channels are assigned automatically. You can
select the central channel by moving the joystick briefly to the left.
GB-10
Transmitted signal is being sent
(bidirectional radio operation)
Channel without programmed receiver
Transmitter channel in bidirectional
programming mode
Positive feedback to the transmitted signal
from the receiver (bidirectional radio
operation)
Unidirectional radio operation: Transmit
signal is being sent
No response from the bidirectional receiver /
channel completely deleted
www.elero.com