Installation Instructions Safety Instructions; Scope Of Delivery; Description; Dimensions - Truma CP plus Gebrauchsanweisung Und Einbauanweisung

Installation instructions
Safety instructions
In-vehicle installations must comply with
the technical and administrative regu-
lations of the respective country of use
(e.g. EN 1648, VDE 0100-721). In other
countries, the relevant regulations must
be observed. National regulations and
rules must be followed.

Scope of delivery

1 Truma CP plus control panel
1 cover (depending on type)
1 screw (fastening control panel upper section)
4 screws for wall mounting (depending on type)
1 set of operating and installation instructions
1 12 V connector cable 30 cm (+ = red, - = red/black)
1 fuse holder with 1 A fuse (depending on type)
1 connector cable TIN bus 6m (depending on type)
To be ordered separately:
CP plus cover
Connector cable (TIN bus) available in different lengths.
Mounting frame DBT

Description

The Truma CP plus control panel (with polarity reversal protec-
tion) is supplied with voltage via a 12 V connector cable. The
control panel is connected to a Combi CP plus ready heater
and / or an air conditioning system or a Truma iNet Box via a
44
connector cable (TIN bus). The independently installed CP plus
control panel is suitable for wall mounting on a level surface.

Dimensions

92
69
11.5
Figure 1 – Dimensions in mm. Illustration not to scale
9
7
22
11.5
18