Steinbach Speedcleaner RX 5 Bedienungsanleitung Seite 9

EN
technical Details
 Rated input voltage: 220(230)VAC
 Frequency: 50Hz
 Output Voltage: DC 24V
 Rated input power: 200W
 Rated output power: 150W
 Frequency of remote control: 2.4G
 Cable length: 18m
 Cleaning band width: 358mm
 Maximum cleaning area: 200m²
 Filtering capacity: 15m³/h
 Filtering capability: 200µm
 Water temperature of use: 10°C - 32°C
 Creeping speed: 12m/min
IP Grade: cleaner-IPX8; power supply unit-IPX4
Working temperature: 10°C - 40°C
 Weight of cleaner: 9.5kg (without cable)
Components of Swimming Pool Cleaner
1. The Speedcleaner RX 5 consists of power supply unit and cleaner
body.
control
board
Preparing for operation
Hitching Cable Hook
Speedcleaner RX 5| 2014_V1
Hitch the cable hook (Fig. 1) to the stationary ring on the lock nut.
Carry the stationary ring and put the cleaner into the pool (Fig. 2). Al-
low all of the air inside the cleaner to flow out completely (Fig. 3)
from the unit. Then The cleaner can sink to the bottom of the pool
(Fig. 4)
Warning: for optimal performance, make sure that there is no air left
inside the cleaner (no more air bubbles come from the cleaner and
the cleaner is completely submerged on the pool bottom).
2
3
power
line
cable socket
Power Connection
Once the cleaner sinks to the bottom of the pool (Fig. 1-2-3), unfold
the power cable in the attached package and plug it into the socket
on power supply unit . Then plug the cable line into the socket; (note:
make sure to plug it in the correct direction and position), and fasten
the nuts on both sides of the plug. Connect the power cord to the
power socket. The unit is now ready to start cleaning.
1
3
Cleaner Operation
1
4
2
Page 9 / 14