Troubleshooting - Steinbach Speedcleaner RX 5 Bedienungsanleitung

EN
cleaner.
Install the stabilizier
Recommend to use this standing nut on the pool cleaner for using in
the pool which has the steps in order to avoid the turn upside down
of pool cleaner.
Align the hole oft he stabilizer tot he hole and the localizer on the top
cover.
Pay attention tot he direction of
the stabilizer
Localizer
Put screw trough the whole and fasten
Apply and fasten the screw to secure stabilizer in position on the
cover. Repeat same assembly for the other 3 stabilizers.
Trouble Shooting
Symptom Possible reason
Cable twisting Cable was not fully
or coils up released
Excess cable in the
pool
Gets stuck on main
drain cover
Cleaner does Power supply
not reach all wrong positioned.
pool areas
Pool filter and pump
is on
Cable not
Page 12 / 14
Corrective actions
Unplug power line, re-
lease cable
Remove excess cable
out oft he pool and en-
sure the proper length of
cable on pool.
Turn off pool filter system
was Place power supply on
position so that cleaner
can reach all areas
Turn off pool filter system
long Release cable
enough in pool.
Cleaner does Filter bag filled with
not climb walls debris
properly
Algae on walls
Water temperature is
too high/low
Brush worn
Cleaner too light –
trapped air
Unsuitable pH Level
The nut on sliding
block is not in proper
position or loose
Cleaner does Power cord not con-
not work nected well
Damaged
transportation
Local rated voltage is
not suitable
cleaner
Cleaner does Air inside cleaner
not sink
Roller/belt cut Debris blocked
driving system
Cleaner float Cleaner climb
out of water high, air in cleaner
Cleaner da- Wrong operation
maged
Warranty in relation to operation safety and reliability is only accept-
ed from the manufacturer under the following conditions:
 The pool cleaner is operated according to the specifica-
tions of the user.
 For repairs, only original spare parts are used (wearing
parts are not subject to warranty).
Consequential damages
For damage to the product, caused by failure to follow the manuel
recommendations, we can not pay.
WEEE EU-Directive
Please respect the European Union regulations and help to protect
the environment.
Return non-working electrical equipment to a facility appointed by
your municipality that properly recycles electrical and electronic
equipment. Do not dispose them in unsorted waste bins.
Replace filter bags
Brush walls
Optimally water tempera-
ture between 10 – 32 °C
Contact dealer, replace
brushes
Turn off cleaner, exhaust
air inside cleaner
Check level between 7.0
– 7.4
Change back to original
position, or contact local
vendor
Plug power cord an cable
line
during Contact local vendor
Contact local vendor
for
Turn off cleaner, ensure
there is no air inside
cleaner and let cleaner
sink to bottom of pool
in Contact local vendor
too Turn off cleaner,
exhaust air. Contact
dealer o fit happens fre-
quently
Contact local vendor
Speedcleaner RX 5 | 2014_V1
re-