Steinbach Speedcleaner RX 5 Bedienungsanleitung Seite 8

EN
Warnings
 In order to prevent severe damage to the
cleaner, never power on the unit when it is
outside of the swimming pool.
 The power cord must be connected to an
appropriate earthed socket.
 Do not operate the cleaner when people are
in the pool.
 Ensure the cable hook is locked to the ring
before immersing the cleaner into water.
When lifting the cleaner out of the water, al-
ways use the ring and never the cable.
 For optimal performance, before power on
make sure that there is no air left inside the
cleaner (no more air bubbles coming from the
cleaner and the cleaner is fully submersed on
the pool bottom).
 Do not try to move the floaters along the
electrical cable. Leave them always in the
original positions.
 Before power on, make sure the cable is ful-
ly released to avoid any winding, which could
affect the cleaner's performance or cause
damage.
 The filter bags should be cleaned every time
you use the unit. This will prevent that the
dirty filter bags affect the normal operation of
the cleaner.
 The cleaner should be stored in a cool and
ventilated place, away from direct sunlight,
when not in use.
 The power supply unit should be placed in a
shaded area. In order to avoid overheating
and potential damage of components, never
cover the power supply unit.
 Only authorized after sales service person-
nel should open the cleaner's power supply
unit and motor assembly, otherwise the war-
ranty will be invalidated.
 Do not use the cleaner beyond the working
environment/conditions stated in this manual.
Please read this instruction manual care-
fully before use and keep it for future ref-
erence.
Introduction
Our automatic swimming pool cleaner Speedcleaner RX 5 is a new,
powerful and automatic system for cleaning swimming
Through its advanced computer controlled program, it can clean the
pool floor and walls automatically without draining pool water. At the
Page 8 / 14
same time, it filters the pool water and gets rid of suspended parti-
cles and sediments.
particles from the floor. An adherent contamination must still be re-
moved manually.
rect current. Please read these instructions carefully in order to use it
properly.
Safety
Position of Power Supply Unit
The power supply unit should be properly po-
sitioned so that the cleaner can reach all the
corners of the swimming pool, and must be at
a minimum distance of 3.5 meters from the
edge of the pool.
Note: Power supply unit should be placed in a
shaded area during operation.
Requirements for Power Supply
Before connecting the power supply to the
cleaner, please check that the rated voltage
and frequency (hertz) of your home corre-
spond to the one of the unit.
Rated input voltage: 220(230)VAC
Frequency: 50Hz
pools.
The Speedcleaner can only absorb loose debris
For safe operation, the cleaner works on 24V di-
Speedcleaner RX 5 | 2014_V1