Steinbach Speedcleaner RX 5 Bedienungsanleitung Seite 10

EN
Item Name Specification
1 Power Power indicator light
2 30s
3 60s Working status indi
4 90s
cator lights
5 120s
Auto 3h indicator
6
light
7 3h Auto 3h button
Auto 5h indicator
8
light
9 5h Auto 5h button
Manual mode indi-
10
cator light
11 FWD/REW FWD/REW Button
12 Power on indicator light
13 Power On
Power ON button
14 Power Off
Power off button
Example
Here is instruction to operate the cleaner in cycle of auto 3h:
Press the button 'Power On' on the panel and the power on indicator
light flashes. Now the cleaner is in standby mode.
Press "3H" button, indicator 6 and 2 in fig will flash and the cleaner
gets into 3h cleaning cycle.
Indicator 2/3/4/5 will flash repeatedly to indicate the current status.
Cleaner will power off automatically after 3h working.
Alarm instructions
When there is a failure alarm, a correspond-
ing indicator light will flash with beep.
Flashing indica- Reasons and methods
tor lights
30, 60, 90, 120 The robot has climbed out
S oft he pool, or there is no
water in the pool.
120 S The robot is not connec-
Page 10 / 14
Function
Will flash when connect
to power
4 lights will flash repeated-
ly under manual mode;
One light will flash under
auto mode, also hast he
function of alarm as stated
bellow in „Alarm instruc-
tions"
Cleaner will work in cycle
of 3 h
Cleaner will work in cycle
of 5h
Press once for forward;
press twice for stop; press
trice for backward
Cleaner gets into standby
mode after pressing this
button
ted. Please connect the
robot cable with the power
supply unit.
All indicator The water pump motor is
lights locked. Please contact a
professional.
90 S The power is abnormal.
Please contact a professi-
onal.
Note: Make sure that the cleaner has been
powered off before lifting out of pool.
Works after use of cleaner
Removing Cleaner from Pool
The cleaner will power off automatically after one cleaning cycle.
Unplug the power cable, pull the cable line slightly and lift the clean-
er by carrying the stationary ring on the lock nut
Note:
1) In order not to scratch the pool wall or damage the cleaner, avoid
the cleaner touching the pool wall during carrying out from pool.
2) Before carrying outside from pool, suspend the cleaner above wa-
ter for about 10-15 seconds to release the water remaining inside
the cleaner.
3) To carry out the cleaner from pool, please hold the stationary ring
only, never pull cable
Put the cleaner on the edge of pool, open the lock nut, and remove
the top cover. Then take out the filter cartridge and take off the filter
bags.
Clean the debris & silt on filter bags using clean water, then reset
onto filter cartridge. There is a filter outlet added into the cleaner, af-
ter using the cleaner, there might be some dirt in it which should also
be cleaned. Then put the filter cartridge back into the main frame of
cleaner.
Positioning
nut
Speedcleaner RX 5 | 2014_V1