Baninni VEGA BNCS020 Gebrauchsanleitung Seite 14

MANUAL
Step 3 The use of the belts
Firstly, the height of the shoulder straps in set. Connect the two metal parts of the closure
together. Connect the two buckle connectors into the slot in the belt until you hear a 'click'.
Make sure the harness is correctly locked by pulling the straps down.
Step 4 Adjusting the seat belts
Step 5 Adjusting the seat in different positions
Pressure on the controller
while the two bands hold
with the other hand. Pull the
shoulder straps towards you
to loosen the belt.
The belts should be adjusted
as tightly as possible without
causing your child feel un-
comfortable.
The car seat can be adjusted
to four different positions: po-
sition 1, position 2, position 3,
position 4 position to the rear
(group 0+) corresponds to the
position 4. Pull the lever under
the front of the seat up, then
pull or push the seat forwards
or backwards. Release the
lever to the desired position
and push until you hear a
click.