Closing The Door - Electrolux IK1695Z Benutzerinformation

62 electrolux
Problem
The compressor does
not start immediately af-
ter pressing the Fast
Freeze or Shopping func-
tion, or after changing
the temperature.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/
high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .

Closing the door

1. Clean the door gaskets.
Possible cause
The room temperature is too
high.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
Fast Freeze or Shopping func-
tions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Switch off Fast Freeze or Shop-
ping manually, or wait to set the
temperature until the function has
reset automatically. Refer to "Fast
Freeze or Shopping function ".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution